Thread: Discussion Walkera V400D02
View Single Post
Old Nov 02, 2012, 08:11 AM
weav01 is offline
Find More Posts by weav01
Pittsburgh, PA
United States, PA, Mt Pleasant
Joined Jul 2012
370 Posts
Just replaced a servo (aileron) and tail motor due to a crash and bad motor. Was going to make some gyro gain adjustments after hovering and noticed some tail wag. When i looked at the gyro it was set on ADJ instead of WK. So i switched it to WK and then my Pitch and Aileron servos move up/down in sync with all right stick movements. In ADJ they move normal. What is happening? By the way this is a DeVO 7 setup.
weav01 is offline Find More Posts by weav01
Reply With Quote