Thread: Question Turnigy 9XR
View Single Post
Old Nov 01, 2012, 02:17 PM
grimbeaver is offline
Find More Posts by grimbeaver
Registered User
United States, MN
Joined Feb 2011
4,385 Posts
Originally Posted by hammer22 View Post
Model match works by sending the model memory position in use in the TX along with the servo position data to the Spektrum TX module (AMTX11). The TX module then takes the model memory number and XORs it with the base TX GUID to produce a new GUID unique to that model memory slot. The TX module then uses that new GUID in every packet sent to the RX. The RX learns that new GUID during the bind, of course, and only responds to data sent using that new GUID.
Thanks hammer22. So in short the module won't really have a workable model memory which was expected, it will send the same GUID to every RX you bind with. If you press that button you will probably get a new GUID and have to rebind all your stuff. I don't get this obsession with model memory anyways. It's a "nice to have" but by no means is it needed.
grimbeaver is offline Find More Posts by grimbeaver
Reply With Quote