View Single Post
Old Oct 30, 2012, 06:49 PM
dkfuji is offline
Find More Posts by dkfuji
RC Helis: My Healthy Obsession
The OC, California
Joined Feb 2007
3,159 Posts
Quote:
Originally Posted by dariobrit View Post
Well... I bought those 7t PN racing... but they're for 1,5mm shaft and my C05 is 1mm...
May be dangerous but I have to try...some melted plastic to fill the .5mm gap in order to fit... Will be tough to make it balanced...
Do you have any ideas how I can do it right?
That pinion looks like its plastic. If it is, you will more trouble than just mounting the gear square on the shaft. I have tried plastic pinions on smooth motor shafts and it just doesn't work out very well. I had to rough up the shaft and epoxy the gear onto the shaft to prevent slipping. The only right way to install the gear would be to pull the old shaft out of the bell and replace it with a 1.5mm shaft and loctite it into the motor bell.
dkfuji is offline Find More Posts by dkfuji
Reply With Quote