View Single Post
Old Oct 29, 2012, 04:44 PM
OICU812 is offline
Find More Posts by OICU812
Registered User
Joined May 2005
914 Posts
Quote:
Originally Posted by Kosmos View Post
This is my first quad - very new to ALL this, but I am very excited to get this in the air - still waiting on ESCs, and other things.....
My plan is a HTFPV frame with:
-Eagletree OSD and logger and GPS,
-ImmersionRC 5.8 vTX
-GoPro flight record
-readymaderc - RMRC-540N video for FPV
-Turnigy plush 30A ESC
-3300mah 3S main lipo
-500mah 3S vTX lipo
-28-26A motors (had to cut the shafts)
-DJI NAZA with GPS
-Eagle tree ground station (readymaderc tracking station)
-Fat Shark goggles

Some suggests most welcome on my wiring diagram I know it is not right - little confusing to a newbie. I also got power distribution plate from HT would like ask for some guidance as how best to solder that up? Would I be better off
with a 750mah for video system? Question on GS - how best to wire up the lipo there would like a dual 5000mah setup - is it best to use a regulator there?
I'll be powering the tracking station and servos, 5.8 video receiver, fat sharks, and perhaps a small LCD of some sort - still working on that idea....
One last thing - how best to power the FPV camera?

Draft Wire Diagram


Ground Station under construction:


Cut down the 28-26A motor shafts:


Shaft almost flush with the motor - but there is room with the motor mounts anyway:


Arms are done and Body shafts installed - I CA'd the motor mounts - hope I don't regret that...


In the mean time I am abusing an MQX quad - to brush up on my flight skills and
get myself comfy with the Specktrum DX8.

TIA
Ground station looks awesome my friend!!
OICU812 is offline Find More Posts by OICU812
Reply With Quote