View Single Post
Old Oct 27, 2012, 09:51 AM
Lynnsabcs is offline
Find More Posts by Lynnsabcs
Registered User
United States, TN, Knoxville
Joined Oct 2012
32 Posts
Cut the fusalge tape to separate and get to the bric. I reversed the servos on the bric and the dead servo switches sides which tells me the servo is not bad. I re-connected the servos in the original configuration.

I tried to reverse the servos using the throttle and aileron controls but I can configure both moving together in same direction. Any other command turns off the servo with the wing hit.

I tried reversing the servos on the aileron option in the radio but it just changes the ailerons from up together to down together.

I guess the next step is buy a replacement servo to get the micro thingy to reverse the servo? Can you buy the reverse connector without buying the servo?


Lynnsabcs is offline Find More Posts by Lynnsabcs
Last edited by Lynnsabcs; Oct 27, 2012 at 09:59 AM.
Reply With Quote