Thread: Discussion RF beacon question
View Single Post
Old Oct 25, 2012, 05:57 PM
crd is offline
crd
Find More Posts by crd
crd
Always thinkering
crd's Avatar
United States, FL
Joined Nov 2006
1,267 Posts
Quote:
Originally Posted by fmkit View Post
all versions have somewhat similar codes and reset the same way (hold button till LED goes off), one can use the beacon without learning a single code (default mode)
Beacon with microphone completely automatic - tones transmitted while plane is still and while motor is running or wind is strong transmission is blocked (standby mode)

to enter specific frequency click 6 numbers like in this video
or use presets , two digit codes 3.2-3.8 for channels 2-8 FRS or PMR if beacon shipped to Europe. Code 3.1 sets previously stored custom frequency, you can switch between presets and custom frequency anytime.

in the last 3 months those asked for no mic version got same regular beacon just without mic.and some resistors and capacitors so there is power saving without constantly connected mic. susch beacons must use menu entry 1,x where x stands for multiplies of 20-25 minutes, enter 1.2 (default) for 40-50minutes startup delay.
Beacons w/mic. don't need startup delay because mic. blocks TX as soon as motor starts

I'll update instructions soon.
Good info, can I change frequencies to a custom one? lets say example 920.210mhz?
crd is offline Find More Posts by crd
RCG Plus Member
Reply With Quote