Thread: Discussion 3DHS 71" Slick on Gas
View Single Post
Old Oct 24, 2012, 10:36 PM
RC_Feen is offline
Find More Posts by RC_Feen
Registered User
RC_Feen's Avatar
Culpeper, VA
Joined Oct 2005
752 Posts
Quote:
Originally Posted by kerwin50 View Post
If you have your servo arm almost parallel to the servo body with the throttle closed. This set up works more closely to 1/4 stick 1/4 throttle, 1/2 stick 1/2 throttle an so forth.
Gas engines do equate to 1/4 throttle 1/4 of max rpm it's very unlinear.

Yes the throttle arm on the carb is parallel to the servo arm when the throttle stick is at 0 or the bottom.


Quote:
Originally Posted by going4speed View Post
The bolded part confuses me. Sounds like end points are too far past the stop on the carb.
I adjusted the end points for WOT to were the carb mechanical end stop just barely touches the mechanical end stop. What I did was moved the throttle stick to full throttle then adjusted the end point to the point were the carb just touches the mechanical end stop. Does that sound right or make sense? Isn't that setting the endpoint for max throttle?
RC_Feen is offline Find More Posts by RC_Feen
Reply With Quote