View Single Post
Old Oct 24, 2012, 09:26 PM
tom3holer is offline
Find More Posts by tom3holer
Cape Cod
tom3holer's Avatar
United States, MA, Barnstable
Joined Sep 2010
960 Posts
V1 Rx will not go into PPM out

Sorry to post this again but was hoping someone might have an idea whats going on here. Received my V1 system with 2 9Ch Rx's back from Mike over a week ago. Followed the new directions about changing Ch9 to ppm out but it will not work on either receiver. Jumped signal pins 7 and 8, rebound and still Ch9 is Ch9. removed jumper and rebound again still Ch9 is Ch9 not PPM output. Tried various combinations and it just won't work. Used a servo to conform output of Ch9.

Does anyone have an idea? I thought perhaps in doing the upgrade both of my Rx's received th 12Ch S/W upgrade by mistake but I have no way of telling?

Thanks,

Tom
tom3holer is offline Find More Posts by tom3holer
Reply With Quote