Originally Posted by Teamsherman
Ok so can someone give me a certain workable combo and I'll order it today.
my set up is
think I saw 13x7 there too, 8mm root and 3mm pin
i have a sentry 40 amp esc, 3amp bec corona 12g metal gear servos for rudder and elevator, 9 gram for ail and flap. so using a 2200 20c 4s nothing special with the batt can use 3s but the batt tray is out and batt is velcroed in on the fus floor as far back as you can get it, against the servo mount. Rx is also slid back past servo mounts, no extra weight added though. nice light spinner required too, 5mm shaft, I don't like any of the hk ones. here is a vid with this set up
if you check back at post 2350, page 157, it is the same set up, have fun