Thread: Build Log 1/6 Scale Ultralight
View Single Post
Old Oct 24, 2012, 04:58 PM
Marked is offline
Find More Posts by Marked
Registered User
Marked's Avatar
United States, FL, Titusville
Joined Jan 2001
505 Posts
The rear attach points are finally aligned and on the frame...still a little off,but not enough to cause any problems.

top view....looks like a plane finally.

I had to beef up the inboard wing rib,since it would be supported by the aft point all the time. Didnt think the balsa rib would take much abuse.

I went through several ways to do this,decided to sleeve the ends so I dont have to make 1 piece and drill both ends perfectly. .....When both sides are aligned,then I can solder the ends in place. Makes it easier to keep both wings at the same angle. Keep in mind,they are independent of each other,making the process a pain in the
Marked is offline Find More Posts by Marked
Reply With Quote