View Single Post
Old Oct 24, 2012, 08:23 AM
OVLegend106 is offline
Find More Posts by OVLegend106
Registered User
Joined Mar 2011
5 Posts
Quote:
Originally Posted by angryfeet View Post
I dont know what speed you need, but what about using a pair of arduinos and multiplexing the data over two channels?

Eg, use one channel for the switch number and the other channel for on/off. The arduino on the Tx side can cycle through the channels and the Arduino on the reciever can demultiplex them.

If your radio lets you mix from the trainer channels then you can make up a simple switch board and then just plug it in.
I thought about using Labview as the software to control these systems, which are then fed to a transmitter. Labview would dedicate certain "go-codes" to certain channels and would control it that way. I don't know how involved that will be since my EE colleague will be the one designing the system in Labview.
That being said, i will check out your suggestion. Theres always more than 1 way to do something, perhaps your suggestion will be less complicated.
OVLegend106 is offline Find More Posts by OVLegend106
Reply With Quote