View Single Post
Old Oct 23, 2012, 11:15 PM
splinterz25 is offline
Find More Posts by splinterz25
Jack of all master of none
splinterz25's Avatar
Baltimore MD USA
Joined Jan 2011
4,832 Posts
Alright after having some input this evening from all three sites it looks like the motion I'm getting is correct.

NOW there will be some tricky lining up of the brass ribs and soldering them just where they need to be

And a few more test be for gluing in the actuator & ribs.
Have a look at both FLAPS just set in place and the amount of throw I'm getting and the drawing it really shows the gaps and the angle of the FLAPS.

Bruce
splinterz25 is offline Find More Posts by splinterz25
Reply With Quote