Thread: Discussion New Blade mQX RTF & BNF
View Single Post
Old Oct 23, 2012, 04:18 PM
desertdweller is offline
Find More Posts by desertdweller
LOOK MOM! TEN THUMBS!
desertdweller's Avatar
USA, AZ, Mesa
Joined Aug 2009
471 Posts
Quote:
Originally Posted by ty_horn View Post
Yeah, I have all of my channels trimmed to zero! I called HH and they said that there could be a problem with the board.
No. I mean lower your throttle trim all the way down to the bottom.

Typically all your trims will be in the center. You will want your rudder trim centered, your aileron trim centered, and your elevator trim centered. Then lower your throttle trim all the way down. If your throttle trim is centered your TX is probably sending a tiny bit of throttle signal to your MQX and the safety features in the esc wont let the esc bind if you have any throttle......kinda the same as if your throttle stick was up a little....it wont bind.
desertdweller is offline Find More Posts by desertdweller
Reply With Quote