Thread: New Product Spektrum DX18
View Single Post
Old Oct 23, 2012, 02:12 PM
ArguZ is offline
Find More Posts by ArguZ
Registered User
Joined Oct 2012
123 Posts
Good evening..

I have a funny problem with my DX18...
In my program for the Beam I set DR and Expo to be switched with the flight mode switch.
As i understand it I can select different curves for different modes.
So i set curve 0 for Hold, Curve 1 for Norm, curve 2 for FM1 and curve 3 for FM2.
Fine...that work for Aileron and Rudder...
But for Elevator, whenever i set it to be switched with the FM switch, FM1 goes back to inhibit after switching to either Noramal or FM2
If I set it to ON only it stays there.
But as soon as I try to alter it with the FM switch, it takes the value until I actually move the switch, then it jumps back to Inhibit.
Should I move on and just delete the program ? Or is that something worth investigating ?
Maybe someone wants the file ?

cheers
Sascha
ArguZ is offline Find More Posts by ArguZ
Reply With Quote