View Single Post
Old Oct 22, 2012, 02:34 AM
invertmast is offline
Find More Posts by invertmast
Registered User
United States, FL, North Port
Joined Mar 2004
3,820 Posts
Thanks john!

I know the v2 would be much easier to model gear wise, i may even do a simpler solid fork the that has the correct profile of the v3, w/o the complexity. It really comes down to the cost of the gear.

The gear doors im sure will be a pain, they almost always are! I plan to use an electric linear actuator for the nose gear. I can get custom gear ratios and strokes to fit my needs.

The CAD tire was just for the drawing purposes to check fit and clearance. In reality, the actual tire to be used will be a 6" inflatable unit from dubro. I will probably end up 3d printed a detail cover for the hub (what little detail there is). The dubro tire is a little undersize, but finding a 7" tire proved difficult on this side of the pond.
invertmast is offline Find More Posts by invertmast
Reply With Quote