Thread: Discussion New SSX Biplane
View Single Post
Old Oct 21, 2012, 05:47 PM
AeroDude is offline
Find More Posts by AeroDude
Eject! Eject! Eject!
AeroDude's Avatar
Dayton, OH
Joined Sep 2004
1,002 Posts
James,

the cross struts are simple, just fishing leader from WalMart.

just cut the connectors off the leaders leaving the loops.

if you find them long enough you will only need one for each side.

I slip the loop over the screw and under the waser and tighten down the screw, run the other end of the leader to the oppisite wing/strut and wrap around and under the screw and washer a couple times hold tight while you tighten the screw, trim the wire.

you can make a more permanent loop by crimping a collar over the wires while holding tight.

I don't plan removing the wings to transport.

AD
AeroDude is offline Find More Posts by AeroDude
Reply With Quote