View Single Post
Old Oct 21, 2012, 02:51 PM
Haych is offline
Find More Posts by Haych
Registered User
Australia, VIC, Melbourne
Joined Mar 2010
484 Posts
Quote:
Originally Posted by Captain3D View Post
Hi Mike

My Tx does not follow the manual or below description. What do I have and what do the lights mean?

The Tx has all flat sides and a low/high switch. With the bind button down and powering up I get...

0-5 seconds = red
Release during this phase and I get a flashing green light at about 4 flashes per second. Is this binding mode ?

5-10 seconds = green
Releasing in this phase gets me alternating red green. Is this calibration mode?

10+ seconds = no light ( dark)
Is this new ID mode?

Where is my orange light?
Where is my micro power mode? ( I have a dummy load)

Is this just another variant that is working fine?

Edit: also I have to push the bind button extremely hard ( beyond the click) and pull it to the left to get anything to happen.

Phil
I answered you after your last post... its yet another version of lights and firmware they used, just prior to adding micro power mode in the mix. You dont have micro power (orange light) , use the dummy cap for range testing. everything else you assumed is correct.
Haych is offline Find More Posts by Haych
Reply With Quote