View Single Post
Old Oct 21, 2012, 02:48 PM
Ospreyman is offline
Find More Posts by Ospreyman
Registered User
Cheshunt, Hertfordshire
Joined Aug 2009
224 Posts
Pic 1 shows the general layout of equipment. The glass fibre board frames attach to the metal heli side frames using existing holes in the metal. This view shows the rake angle of the shaft in relation to the keel tube (datum) 8 degrees.

Halfway up the GF frames 6mm holes were drilled, 6mm CF tube cyanoed in to provide a base for another horizontal GF board between the sides. This board houses the 2 ESC's and the RX (underneath) also seen here is the butchery to fit the motor mount
The bottom of the GF side frames are drilled to take the 8mm axle support. The 6mm axle slides into that and is cyanoed. the two cyclic servos can be seen in this pic too

Pic 2 shows the minimum heritage tailplane

Pic 3 shows the motor and amount of offset

Link for 4 blade head

http://www.ebay.co.uk/itm/Flybarless...item46085a2da6

try that
Ospreyman is offline Find More Posts by Ospreyman
Last edited by Ospreyman; Oct 21, 2012 at 04:33 PM.
Reply With Quote