Thread: Discussion QTR Quad Tilt Rotor
View Single Post
Old Oct 20, 2012, 07:45 PM
tom-tom 1 is offline
Find More Posts by tom-tom 1
Registered User
Joined Jun 2010
61 Posts
The 1300 min throttle was the turnigy 10A the line above the simple 10A esc.

The roll and pitch travel adjustments are at 150% on my DX8. I get 1194-1789 on the roll and 1197-1796 on pitch. I'll adjust R and P to 1250-1750.

I suppose you would adjust the P settings up. I also suppose you would change the P settings and then push "write"?

My failsafe did not stop the motors. Everything else seems to be right. With the motors about half throttle the sticks seem to work the right motors and when I move the frame around the correct motors seem to resist the changes in attitude. I hope to try it out tomorrow, the weather should be great.
tom-tom 1 is offline Find More Posts by tom-tom 1
Last edited by tom-tom 1; Oct 20, 2012 at 09:30 PM.
Reply With Quote