Thread: Build Log IOM Scratch Build
View Single Post
Old Oct 20, 2012, 03:50 AM
coolmobility is offline
Find More Posts by coolmobility
Registered User
coolmobility's Avatar
Australia, VIC, Paynesville
Joined Sep 2009
240 Posts
My Jib sheet goes through a side then top, loop fitting soldered to a bolt but I must admit that the jib sheet wears more than the main. These rings are oriented port/starboard. I've seen very neat setups where just a "U" bend of stainless wire is inserted through two tiny holes and epoxied under deck - nothing to wrap around, very light and should be robust.

My jib swivel points are Pekabe Eyebolts P455 out of interest.
coolmobility is offline Find More Posts by coolmobility
Reply With Quote