Thread: Discussion Eurocopter tiger
View Single Post
Old Oct 19, 2012, 04:19 AM
viggen65 is offline
Find More Posts by viggen65
Registered User
Sweden, Gothenburg
Joined Aug 2005
821 Posts
Hello guys

after some thinking I decided to mount Tf models Imds system on mine Tiger, this because some wonderings and of course my own curiousity

The biggest issue was that a hole had to be done on the other side of the fin
but in the end this didnt ended up so bad at all, im gone clean up the whole and maybe put some alumesh around the whole motor, as you see I have used kins raised tail sys also, this is because i didnt want to use the plastic gearbox suoolied whit the kit, the gears gone be taken out since there no point to have them more, of course attention now has to be taken to get the cg right but dont think this gone be a issue since theres lot of room for the batteries in the front of the fuse and also the imds system is requirering a separate battery, in my case
3s 5000 mah, I have ordered 690 mm halfsymmetrical blades from scaleflying.de
and decided to go for a 8s setup, I had this in mine Hirobo panther with good result and have calculated a main rpm about 1300, the best thing is that the whole tailsystem can be removed without lifting the main mech out in case of maintance.

Cheers
Jack
viggen65 is offline Find More Posts by viggen65
Reply With Quote