Thread: Discussion QTR Quad Tilt Rotor
View Single Post
Old Oct 17, 2012, 06:27 PM
tom-tom 1 is offline
Find More Posts by tom-tom 1
Registered User
Joined Jun 2010
61 Posts
I received 2 new ProMini boards yesterday. I loaded one up with the 1.7 code, attached the WMP board and the GUI works. I installed the boards on my quad copter and assembled the bec, escs, motors and receiver using your diagram.

I turned on the transmitter and plugged in the battery. The motors start in the correct direction when I move the throttle to the minimum and yaw left. They run about half throttle at min. and will run up to full throttle. Nothing seems to change when I move the copter. The motors change very little when I move the yaw, pitch, and roll stick. The motors quit when I move the throttle to the minimum and yaw to the right.
My throttle cut doesn't work.

I had to use full min. trim on throttle and 150% sub trim travel adj.on yaw to get the motors to start.
tom-tom 1 is offline Find More Posts by tom-tom 1
Last edited by tom-tom 1; Oct 18, 2012 at 08:25 AM.
Reply With Quote