View Single Post
Old Oct 17, 2012, 01:24 PM
Mr_westie is offline
Find More Posts by Mr_westie
YS-X6 Know why it crashes,blog
New Zealand, Auckland
Joined Nov 2007
583 Posts
Quote:
Originally Posted by ArturARM View Post
I have update the new firmware, I clibrated all settings ,but my copter cannt fly stabil. Every time it fly to right or back(Real servo position Elevator begin change from pull1 to pull 6), that problem in all mode(manual,manual altitude, GPS) When I start motors and truttle is under 20% in date menu real servo position Elevator is in MP ; when the truttle is more 21%(23% copter in ground ) , the Elevator begin to change the pull1 and more pull9, I think it will be from motors electrical noise and unplug the motors power and but it is same.can anybody know whats problem?
X650 V4 MT3506 Funfly 18A 13x4.7 prop. YS-X6, 3S
If you try to lift off slowly if may flip.
You have to lift off quick.
Slowly raising the throttle will do this
ys X6 problem (2 min 51 sec)

Note I have scrapped this frame due to vibration issues.

I can have a look at you hj file too.
Please post a picture of your system and a video.
This will help a lot with troubleshooting.
Mr_westie is offline Find More Posts by Mr_westie
Last edited by Mr_westie; Oct 18, 2012 at 04:10 AM.
Reply With Quote