Originally Posted by jabsten
Can the gee bee brick be programmed for an as3x sbach build?
No need, The Gee Bee uses the same config as the B3D so just drop it in and go!
make sure you place it correctly (aft of the Normal Sbach RX location) so the CG is right.
Originally Posted by erkq
Don't forget about the 2300kv motor with a 5043 prop... also way better than the 2500 on any prop and within a hair of the 3000 combo. The tiny bit I give up in performance is more than made up for by the peace while flying.
Yep almost as much power, however the characteristics are different. The 3000kv and 5030 is more responsive having quicker acceleration and holds power/speed better in high G turns and verticals.
The 2300+5043 has a higher top speed but bleeds speed in high G.
Vertical is unlimited on both with a nod to the 3000 for the instant punch acceleration out of a hover. However both do accelerate on te way up to a dot.
I fly in a very tight space so I prefer the 3000kv. If I had a 600ft+ area I'd probably use the 2300+5043 for the top speed increase. Just make the turns more sweeping and manage the energy.