Thread: Discussion Multiplex Funjet Ultra
View Single Post
Old Oct 16, 2012, 06:43 PM
nofreee is offline
Find More Posts by nofreee
Registered User
nofreee's Avatar
United States, CA, San Diego
Joined Jan 2012
294 Posts
Quote:
Originally Posted by GryphonRCU View Post
nofreee,

If it was mine, I would just start with APC E 5.5X4.5 and a good size heat sink and some throttle control.

Check temps, Measure the speed and take it from there.

Hopefully others who know that specific motor will chime in.

Note: the motor is not maxed out yet......everything should run real nice.
***Don't count out 5.5X5.5 yet.

APC 5.5X4.5 will be more fun than 5.2X5.2 Graupner but consider picking that up sometime and see how you like the speed etc.


Per cell Voltage under load: (Watts / AMPs) / 4

Gryphon
Thanks. I'm about the hit the field in a few minutes and will see how she does.

I'm going to start with the 5.25x4.75 and check the temps before moving up as I don't have a heatsink on it right now.
nofreee is offline Find More Posts by nofreee
Reply With Quote