Originally Posted by speedy01
Here's the start of the full scale (not undercambered) wing. I based the frame on a paper model, and built up the wing with various thicknesses of Depron: spars = 1.6mm; Ribs = 2.5mm; top/bottom sheeting = 1.1mm.
Next step is to add the wing servo, ailerons, and mechanics. Then I'll add a CF leading edge, close it all up (building in a little wash out), and apply the ROF tissue.
What did you do for the wing tips ... I can't quite make it out from the fotos.
Did you bake an airfoil into the upper and lower halves?
Out of curiosity, why are you doing a b/u wing?
Would you please post the weight of the wing when completed?