Thread: Discussion Multiplex Funjet Ultra
View Single Post
Old Oct 16, 2012, 05:39 PM
GryphonRCU is offline
Find More Posts by GryphonRCU
Registered User
GryphonRCU's Avatar
United States, CA, SF
Joined Mar 2008
4,033 Posts
nofreee,

If it was mine, I would just start with APC E 5.5X4.5 and a good size heat sink and some throttle control.

Check temps, Measure the speed and take it from there.

Hopefully others who know that specific motor will chime in.

Note: the motor is not maxed out yet......everything should run real nice.
***Don't count out 5.5X5.5 yet.

APC 5.5X4.5 will be more fun than 5.2X5.2 Graupner but consider picking that up sometime and see how you like the speed etc.


Per cell Voltage under load: (Watts / AMPs) / 4

Gryphon
GryphonRCU is offline Find More Posts by GryphonRCU
Reply With Quote