Thread: New Product BLADE130x ????????
View Single Post
Old Oct 16, 2012, 11:30 AM
crvnation is offline
Find More Posts by crvnation
Suspended Account
Joined Sep 2012
428 Posts
Quote:
Originally Posted by rsmheli View Post
HH is also sending me a tail hub.
He said it may have been bent during the tail explosion.
I will check and see if mine is square and balance the blades.
Can these hubs be straightened?
I looked at the spare parts at my LHS and most of them were not square.
I could see with my own eyes there were not correct.
Out of the five they had in stock, only one appeared to be square and correct.
I purchased that one!
Very poor QC!
I've seen where people have actually pulled the hub off the shaft, re-drilled it and fixed it with silver solder, JB weld, etc. More work than I wanted to do. Luckily, I was able to visually inspect and pick up a couple of straight ones from my LHS. I "made" Horizon keep sending me tail shafts/hubs until I got square ones to replace the crooked ones I'd purchased sight unseen from them on-line.
crvnation is offline Find More Posts by crvnation
Reply With Quote  (Disabled)