View Single Post
Old Oct 15, 2012, 08:55 PM
flyrtim is offline
Find More Posts by flyrtim
Registered User
United States, NM, Santa Fe
Joined Aug 2011
411 Posts
I started a new thread in the battery section and haven't had much response
so I will try here

What is best way to convert nanotech 300 with red jst to the UMX plugs (JST-PH) ?
for use with Eflite UMX planes like beast and sbach there are some 2s 300mah nanotech batteries that come with a red JST connector.
I use UMX connector (JST- PH). How to convert....

here is pic of battery

http://www.hobbyking.com/hobbyking/s...Lipo_Pack.html


So, can I simply cut off the jst xh balance tap--and using one of the jst wires splice in the the 3 wire UMX connector--shown here? Then I would just cut off the JST connector altogether since balancing and charging happen through the UMX connector.
http://www.rc-connectors.com/index.p...ki0ejgt0hm7p05


OR
use this adapter through balance plug..
can the balance wires handle the load ?
http://www.rc-connectors.com/index.p...ki0ejgt0hm7p05


OR

I could just convert the the plug and not splice a lead. If I use this kit do I need a special tool ?

http://www.rc-connectors.com/index.p...ki0ejgt0hm7p05
flyrtim is offline Find More Posts by flyrtim
Last edited by flyrtim; Oct 15, 2012 at 09:04 PM. Reason: update links
Reply With Quote