Thread: Discussion IOM General Discussion
View Single Post
Old Oct 15, 2012, 06:08 PM
jims123 is offline
Find More Posts by jims123
Registered User
jims123's Avatar
USA, CA, San Diego 92120
Joined Oct 2007
3,084 Posts
Quote:
Originally Posted by The Tug View Post
Ok extraction ,remove drum from winch tape it and leave it in the boat now you'll see the 2 screws holding the winch on the board the winch has 2 wires to come out with it power lead and servo lead you're done put it back up in reverse.Oh tie a string on to the wires so you can pull em back in.
Sorry you were typing this as i was just replying immediately above.. I will try doing this instead! This way seems a LOT simpler
jims123 is offline Find More Posts by jims123
Reply With Quote