View Single Post
Old Oct 15, 2012, 04:10 PM
maximus-rc is offline
Find More Posts by maximus-rc
RTF copters maker
maximus-rc's Avatar
South France
Joined Jan 2008
1,186 Posts
Quote:
Originally Posted by KariY View Post
It's right but have you checked from CGS that failsafe is working properly and goes to RTH mode? You need also to put channel 5 to position 3 and channel 6 to position 1 in failsafe.
If i remember right i have set F/S to go to ch5/pos3 and ch6/pos3 to go straight to rth.
From manual page 35:
RC Signal Lost
Users must refer to the instruction of remote control transmitter to correctly set up F/S, and set CH5 to position 3,CH6 to position 1, throttle stick to the middle position (installation guide has tips).If enable F/S for any reason in “RC on” status, the autopilot will be switched to auto- hovering status(continue flight path for 3 seconds in auto-waypoints mode, wait for 3 seconds and start to return home if the signal can’t recover after 3 seconds.
That's ok, all F/S are set properly...
it's just looks like the batteries are on low voltage protection...
maximus-rc is offline Find More Posts by maximus-rc
Reply With Quote