View Single Post
Old Oct 15, 2012, 09:33 AM
mlebret is online now
Find More Posts by mlebret
Registered User
mlebret's Avatar
France, Bretagne, Combrit
Joined Mar 2005
388 Posts
Wifi Modem Reset

As a new user of the YS-X6, I messed up the settings of the wifi modem and was no more able to access it. Unfortunately ZeroUAV was of no help with that issue.

Digging the net I found the web site of the Wifi module maker and some valuable documentation.

There is a reset procedure involving the opening of the case and shorting LED_NET pin to Ground for 3 sec during startup. When done you have to redo the settings according to YS-X6 documentation and save them, from the USR-WIFIMOD factory state.

In factory state(initial configuration), USR-WIFIMOD-II behaves as below:
􀂄 It’s NET&SERIAL LED Blink in every 2seconds.
􀂄 It will work in adhoc mode,whose ssid is “wifimodII@192.168.1.254”
􀂄 It holds a staticIP address “192.168.1.254”
􀂄 It works in Udp2Serial mode, and serial access port is 55555.

You have to set your PC TCP/IP properties with
IP static address: 192.168.1.105 (Exemple)
Subnet Mask 255.255.255.0
Default gateway: 192.168.1.254

No Wifi protection,

then access the Setup Web page 192.168.1.254 ( admin/admin as UserName/Password)

It may help.

Marc
mlebret is online now Find More Posts by mlebret
Reply With Quote