Thread: Discussion Walkera V450D01
View Single Post
Old Oct 15, 2012, 05:12 AM
A VIKING is offline
Find More Posts by A VIKING
Registered User
A VIKING's Avatar
Joined Mar 2012
1,611 Posts
Originally Posted by IntegrityHndywrk View Post
Well i think they clone Align. So i think the Align/Tarot tail shaft is basically the same for the belt drive. So I'd bet it will fit. I already ordered replacements though.

BTW, do you guys have any play in your tail grips on the shaft? just wondering. because looking at this new heli. The grips seem secure and installed properly but there is maybe a 1mm gap where they can kind of slide around. Almost like i left a washer out. I don't want to break it down if you guys can confirm some play in yours as well?
Mine have no play, rotationaly they are free and have no radial or axial play.
Because of your issue I have started oiling the grips by letting oil wick into the grip at the root end with the hopes that centrifugal force will push the oil through the bearing stack up. We will see.

A VIKING is offline Find More Posts by A VIKING
Last edited by A VIKING; Oct 15, 2012 at 08:54 AM.
Reply With Quote