Thread: Discussion Walkera V450D01
View Single Post
Old Oct 14, 2012, 07:14 PM
IntegrityHndywrk is online now
Find More Posts by IntegrityHndywrk
IHW Heli Division
IntegrityHndywrk's Avatar
United States, FL, Palm Coast
Joined Mar 2012
8,601 Posts
Quote:
Originally Posted by clearprop88 View Post
I'm not sure the Tarot grips will fit. They just have a 2mm threaded hole for the pitch control arms, so there's a good probability that they will fit. If you want to try them call Tarot RC. They're in San Diego. They may be able to answer the question.
Well i think they clone Align. So i think the Align/Tarot tail shaft is basically the same for the belt drive. So I'd bet it will fit. I already ordered replacements though.

BTW, do you guys have any play in your tail grips on the shaft? just wondering. because looking at this new heli. The grips seem secure and installed properly but there is maybe a 1mm gap where they can kind of slide around. Almost like i left a washer out. I don't want to break it down if you guys can confirm some play in yours as well?
IntegrityHndywrk is online now Find More Posts by IntegrityHndywrk
Reply With Quote