View Single Post
Old Oct 14, 2012, 01:34 AM
MTHead4u is offline
Find More Posts by MTHead4u
Having fun again!!
MTHead4u's Avatar
United States, AZ, Queen Creek
Joined Aug 2012
87 Posts
Wow, fitting a Naza in there without the spacers will be perfect, They measure in at .73" I picked up another Naza/GPS yesterday for this, couldn't pass up the sweet deal.

Depending on shielding from the GroPro (still researching this) I was thinking GPS up front and FPV out the back. I haven't even thought about ESC's yet, was planning on just getting the 30A DJI ones for ease due to running the Naza. Wonder if they will stack on both sides of the Naza, at 1.0" wide they are to big to stand on their sides.

How much room is left on either side of the Naza before you run out of frame? Only need a total of 2.0" (1.0" per side) and they can be stacked together 2 per side. That could also make for some clean wiring if they were 180 of each other so the motor connections plugged right in coming out of the booms. Of course then I'd have to deal with power distro.

Definitely no hole in the top, it looks to good all sleek and clean to have anything protruding from the top. I'd take a lower plate though, with no extra holes in the frame. It would be a good place for a power distro board or the Quattro if the spacers were tall enough.

I can still work with what you
MTHead4u is offline Find More Posts by MTHead4u
RCG Plus Member
Latest blog entry: er9x and Naza Setup
Reply With Quote