Thread: Question Double horse 9116 Heli
View Single Post
Old Oct 13, 2012, 06:00 PM
navycookie is offline
Find More Posts by navycookie
Registered User
Joined Oct 2012
5 Posts
No , I'm not attached to a ship, I work on the electronics of P-3C Orion(too big to land on a ship, actually too big/slow to take off from a ship.) We are deployed in the middle east , the sand here is like dust, it doesn't come off with an air compressor, you have to wipe everything down. I inspected the wires running from the tail rotor-pcb , no cracks. I did notice a good amount of dirt inside the tail motor, I don't have anything that small to reach it, I'll try blowing it out again. this is probably nothing but I tried binding the dh9116 with my wl v911 transmitter , everything works except the tail rotor. Thanks for the advice.
navycookie is offline Find More Posts by navycookie