View Single Post
Old Oct 13, 2012, 05:22 PM
ajbaker is offline
Find More Posts by ajbaker
Argue for your limitations
ajbaker's Avatar
Lincoln, CA
Joined Oct 2006
8,430 Posts
Quote:
Originally Posted by Shimmy View Post
Clevis and Control rods.
<snip>
I know that I asked this before, but no one had the info handy then. If I understand, the stock control rods are too thin for standard clevis thread. I would get new rods and clevis if I knew which ones to get.
Can anyone point me at rods & clevis that will work?
Thanks
I apologize for missing your last post. This thread moves so fast that once in a while, a question falls through the cracks. You did the right thing, though. If you feel your question was missed - ask again. You are NOT being ignored! Again, sorry.
Ok. Having said that, here is one possible solution to your question.
http://www3.towerhobbies.com/cgi-bin...?&I=LXD884&P=7
You will have to solder (or otherwise connect) two of the pushrods to make one that is the ~22" length that you need. Good luck.
AJ
P.S. That is a very commonly used push rod assembly. You should be able to find them at your LHS.
ajbaker is offline Find More Posts by ajbaker
Reply With Quote