View Single Post
Old Oct 13, 2012, 04:07 PM
Daryoon is online now
Find More Posts by Daryoon
Team WarpSquad
Daryoon's Avatar
San Diego, CA
Joined Dec 2010
7,672 Posts
@seahawk1984

I use an xacto knife to start a hole. Then use one of those pointed small screws that are common on these micro helicopter. Screw it into that starter hole. The thread will start to bite. Then use a pair of plier and pull the tab out. Very easy to do and all the tools are already on the typical hobbyist bench.
Daryoon is online now Find More Posts by Daryoon
Reply With Quote