View Single Post
Old Oct 13, 2012, 03:32 PM
igotit is offline
Find More Posts by igotit
Registered User
United States, LA, Houma
Joined Jun 2008
1,706 Posts
ive installed the gears,had to trim the grub screw on the vertical gear,mesh feels great,gears went right on with no slop.this machinist is good....cant beat it for $30.gonna go charge my batts and give em a try....after i lube the lower unit.
i adjusted the mesh a lil on the tight side to allow the gears to wear into each other,alittle tight spot...but not too tight to deter me from running them.


stock brass gears on the left,phosphor bronze on the right.


igotit is offline Find More Posts by igotit
Last edited by igotit; Oct 13, 2012 at 04:11 PM.
Reply With Quote