View Single Post
Old Oct 12, 2012, 10:37 PM
invertmast is online now
Find More Posts by invertmast
Registered User
United States, FL, North Port
Joined Mar 2004
3,796 Posts
Didn't do much today, kinda took a breather for a bit...

But I did do the first round of sanding of filler on the top of the fuse, then put the 2nd round of filler on. Also did the prelim trimming of the inlets, still more work to do to those.


Then enlarged the wing tube holes in the junction rib so the wing tube sockets would fit through, then flopped the whole thing over, aligned the wing panels and epoxied the wing tube sockets in place. all to do now, is to let it cure overnight, cut the outer wing panels free, trim the trailing edges and then start sheeting/planking the bottom. I figure i'll be pretty close to done building wise by the end of tomorrow, so when I return, I can finish the last bit of shaping/sanding and then start glassing everything.

invertmast is online now Find More Posts by invertmast
Reply With Quote