Thread: New Product Eflite Fiberglass EDF HABU Thread
View Single Post
Old Oct 12, 2012, 07:46 PM
Extreme_RC is offline
Find More Posts by Extreme_RC
Extreme CNC Alloy EDF
Extreme_RC's Avatar
Australia
Joined Mar 2006
12,001 Posts
Its not hard to drop the housing in place then sit the brackets in on the rails and tack them on, then remove and glue fully, same with my alloy housing, drop it in and silicon the brackets down in the right spot, let cure then lift it all out to finish off if needed.

I am going to remove 10mm from the front of all the 80mm housings from now on, with the new jetfan rotor having no adapter hub sticking out the back I dont need the extra housing length, will make it easier for installs into the tight area of the Habu.
Extreme_RC is offline Find More Posts by Extreme_RC
Reply With Quote