View Single Post
Old Oct 12, 2012, 05:16 PM
nick_75au is online now
Find More Posts by nick_75au
NeverAgainVolunteerYourse lf
nick_75au's Avatar
Australia, QLD, Regents Park
Joined Mar 2007
3,775 Posts
This is something I would not know how to make work (and forgive the lack of proper RF terminology ) but the RF deck is fed the PPM signal, If you disabled the RF deck and fed the PPM signal direct to the CAT 5, then figured out where the RF in the receiver converts back to PPM and feed the CAT 5 wire into that point. maybe no attenuation would be required and perhaps the PPM signal would be a suitable form to not need shielded wire.

I vaguely remember using the trainer port PPM signal and feeding that to the co-ax and having it work< it was a good while ago and would need some experimentation

Nick
nick_75au is online now Find More Posts by nick_75au
Reply With Quote