View Single Post
Old Oct 12, 2012, 10:06 AM
Sudsy is offline
Find More Posts by Sudsy
It's Just a Hobby!
Sudsy's Avatar
Joined May 2012
1,202 Posts
[QUOTE=Upup;22979727]
Quote:
Originally Posted by Sudsy View Post

Hi the board was powered M1 was connected, the screen powered up, as was 2-3-4 I did try disconnecting 2-3-4 leaving M1 to provide power in case there was a conflict between one of the esc

The board has always had power the KK screen receiver test showed 0 on the throttle I did try calibrating the esc via the kk2 but that caused the screen to blank

So now I have two problems

Jeff
Well I shipped one back defective yesterday. I also went ahead and ordered another so I don't have to wait three months to finish my micro-quad. The new one shipped today. This will be my third board. Maybe since they seem to have increased production to meet the demand the QA is lacking.

Sudsy
Sudsy is offline Find More Posts by Sudsy
Reply With Quote