Thread: Build Log A10 twin 50mm
View Single Post
Old Oct 12, 2012, 07:44 AM
Lt599 is offline
Find More Posts by Lt599
Registered User
Lt599's Avatar
United States, WA, Shelton
Joined Feb 2012
722 Posts
Quote:
Originally Posted by TANGOSIERRAROM View Post
When ESCs come from the factory the settings are in their default setting. However the throttle end points are not set until you programme them in. Some might be close to your tx's signal so are pretty close others can only be set to give about ffty percent power when your tx is at full throttle. the manual should tell you how to do this.
I have never had to program throttle end points on an ESC? I have programmed braking, starts, and cut offs. I tried to find some info on this online but found nothing for this ESC. The ESC's did not come with any paperwork and there was no mention of that programing function in the online manual from HK? I was trying to reset default (just to see) when the one smoked I still have the other one, maybe I could get it to work if I had more info
Lt599 is offline Find More Posts by Lt599
Reply With Quote