Thread: Discussion V-Bar Firmware update
View Single Post
Old Oct 12, 2012, 05:18 AM
Racer_X is offline
Find More Posts by Racer_X
Registered User
Россия, город Москва, город Москва
Joined Jan 2011
5 Posts
The main problem is that the SK's (540, 720) does not pass though a throttle signal below idle throttle point, calibrated in Skookum setup software. You need to set the SK's idle thottle to esc arm point, not to hold point as setup program advises. Currently it is the only one solution (as I know), as long as Skookum is not make changes in firmware. If they're going to do it...
Sorry for my English.
Racer_X is offline Find More Posts by Racer_X
Reply With Quote