View Single Post
Old Oct 12, 2012, 04:05 AM
Upup is offline
Find More Posts by Upup
Registered User
Upup's Avatar
Ilford,Essex, UK
Joined May 2006
2,068 Posts
[QUOTE=Sudsy;22976906]
Quote:
Originally Posted by Upup View Post


The M1 connector must be on to power the board. Not like a receiver the KK2 only gets power on the M1 connector.

Hopefully this is/was your problem.

Sudsy
Hi the board was powered M1 was connected, the screen powered up, as was 2-3-4 I did try disconnecting 2-3-4 leaving M1 to provide power in case there was a conflict between one of the esc

The board has always had power the KK screen receiver test showed 0 on the throttle I did try calibrating the esc via the kk2 but that caused the screen to blank

So now I have two problems

Jeff
Upup is offline Find More Posts by Upup
Reply With Quote