Thread: New Product Pike Perfection
View Single Post
Old Oct 11, 2012, 11:06 PM
tewatson is offline
Find More Posts by tewatson
Tut, Tut...
tewatson's Avatar
United States, CA, Orange
Joined Oct 2006
2,539 Posts
So what is considered "in section" for this wing? There is no fixed reference point for the control surfaces to use in setting the servo linkages up. If I line up the inboard seam lines on the flap and wing root, there appears to be a fair bit of undercamber (about 3mm gap at the hinge line, for a straightedge across the wing bottom touching the TE and the spar area).

Tom
tewatson is offline Find More Posts by tewatson
Reply With Quote