View Single Post
Old Oct 11, 2012, 08:23 PM
wparsons is offline
Find More Posts by wparsons
Registered User
wparsons's Avatar
Canada, ON, Whitby
Joined Aug 2008
9,048 Posts
What pot are you planning on hooking up a control horn to?

A servo tester sends the signal to the servo to make it move just like a receiver would. An ESC runs off that exact same signal, so a servo tester will do the same thing with an ESC.

I'm a little confused by how you plan to power it with three 6v packs, but only put two of them into the ESC? If you want to run 18v, all 18v need to go through the ESC. You can't send half the power through the ESC and just add in more between the ESC and motor.
wparsons is offline Find More Posts by wparsons
Reply With Quote