Thread: Discussion V-Bar Firmware update
View Single Post
Old Oct 11, 2012, 08:18 PM
neoalchemist74 is offline
Find More Posts by neoalchemist74
Fly,crash,repair,repeat.
neoalchemist74's Avatar
United States, CO, Longmont
Joined Oct 2011
40 Posts
Ok if I set the end points directly from the reciever I can then arm the esc. I can even switch the lead back to the Sk540 and it wiill continue to work,but if I unplug then attempt to re-arm then its back to the flashin red light. Also if I try to re set the sk540's throttle calibration after setting the esc end pionts via the receiver then again FLASHING RED LIGHT.
neoalchemist74 is offline Find More Posts by neoalchemist74
Reply With Quote