View Single Post
Old Oct 11, 2012, 06:31 PM
Eagle202 is offline
Find More Posts by Eagle202
Registered User
Eagle202's Avatar
United States, FL, Clearwater
Joined Aug 2011
1,612 Posts
Quote:
Originally Posted by cherbini View Post
Hey All,

Just ordered a SkySurfer from RMRC and the outrunner pod from smallpartscnc. I'm going to load it up with FPV and autopilot/telemetry, etc...

My trusty easystar lost the rudder servo in flight and absolutely augered into the ground from 100ft.

I have the 2200kv inrunner from HK that was in the ez, a 850kv outrunner from a quad, and the 1200kv Ritewing OEM motor from my ZII that had a good life and quick death.

I'd like to know if the ritewing motor swinging an 8x6 or so would just be too much for a loaded down SkySurfer? I think the 850kv would be a bit of a slug, but the 2200kv inrunner worked OK in the loaded down ez using a 6x4. I was using a 3s 2600mah lipo in the ez, and planned on using a similar battery in the SS.

I appreciate your opinions!

I have the same 1200kv ritewing motor but use a 10x6 prop on my ZII with 3S batteries. I don't think an 8x6 prop would fit your SS. You need to go smaller 6x4 which then means more rpm or kv for the motor. 1200kv may not be enough.
Eagle202 is offline Find More Posts by Eagle202
Reply With Quote